# Copy to .env and fill in. Never commit .env - it holds the WiFi password.

# Required
WIFI_SSID=your-ssid
WIFI_PASS=your-password

# Optional

# Armor plates (armor/). Which team this board belongs to: 0 = team one (red),
# 1 = team two (blue). Decides the LED colour and the `team` field in the health
# reports, so it is baked in at build time - reflash to switch teams.
#ARMOR_TEAM=0

# Armor plates: raw 12-bit ADC level above which a piezo sample counts as a hit
# (default 2000, same as the reference firmware). Calibrate from the `peak[...]`
# field in the serial status line: idle noise well below, a real tap well above.
#ARMOR_THRESHOLD=2000

# Capture resolution: qqvga | qvga | cif | hvga | vga | svga | xga | sxga | uxga
#CAM_RES=vga
# JPEG quality 0-63, lower is better quality
#CAM_QUALITY=12
# Set to 0 if your board inverts VSYNC in hardware.
#CAM_VSYNC_INVERT=1

# Pin the authentication mode instead of trusting the scan: none | wep | wpa |
# wpa2 | wpawpa2 | wpa3 | wpa2wpa3 | wapi. Only needed when the scan cannot see
# the AP (a hidden SSID, for instance) - otherwise the scan reports the real
# mode and this only makes it fail faster.
#WIFI_AUTH=wpa2